Schneider Atv12hu22m2 2.2kw Speed ??Controller

Product Features Product destination: Asynchronous motors Component name: ATV12 Internal fan: With Network number of phases: 1 phase Motor power kW: 2.2 kW Motor power hp: 3 hp Line current: 24 A at 200 V 20, 2 A at 240 V Speed ??range: 1?20 IP degree of protection: IP20 without cover plate on the upper part Product series: Altivar 12 Product or component type: Variable speed drive Product-specific application: Simple machine Communication port protocol: Modbus [Us] nominal supply voltage : 200…240 V – 15…10 % EMC filter : Integrated Supplementary Features Supply frequency : 50/60 Hz +/- 5 % Type of connector : 1 Modbus for RJ45 (front) Physical interface : 2 wired Modbus for RS 485 Transmission frame: Modbus for RTU Transmission rate: 4800 bit/s 9600 bit/s 19200 bit/s 38400 bit/s Number of addresses: 1?247 for Modbus Communication service: Read standby registers (03) 29 word Single write registers (06) 29 words Write multiple registers (16) 27 words Read/write multiple registers (23) 4/4 word Read device identification (43) Continuous output current: 10 A at 4 kHz Maximum transient current: 15 A for 60 s Speed ??controller output frequency: 0.5?400 Hz Braking torque: Up to 70% of the nominal motor torque without braking resistor Output voltage: 200…240 V 3 phase Electrical connection: Terminal, clamping capacity: 5.5 mm?, AWG 10 (L1, L2, L3, U, V, W, PA, PC) Tightening torque : 1.2 Nm Insulation : Electricity between power and control Supply : Internal supply for reference potentiometer: 5 V DC (4.75 ?5.25 V), 11 V (case 1) Sampling time : Logic input for 20 ms, tolerance +/- 1 ms Analog input for 10 ms Linearity error : Analog input for +/- 0.3 % of maximum value Analog output type : AO1 software-configurable voltage: 0…10 V, impedance: 470 Ohm, resolution 8 bit AO1 software-configurable current: 0…20 mA, impedance: 800 Ohm, resolution 8 bit Digital output type : Logic output LO+, LO- Protected relay output R1A, R1B, R1C 1 K/A Minimum switching current: 5 mA at 24 V DC for logic relay Maximum switching current: 2 A 250 V AC inductive cos phi = 0.4 L/ R = 7 ms logic relay 2 A 30 V DC inductive cos phi = 0.4 L/R = 7 ms logic relay 3 A 250 V AC resistive cos phi = 1 L/R = 0 ms logic relay 4 A 30 V DC resistive cos phi = 1 L/R = 0 ms logic relay Braking to stop: With DC injection,