Janome R-ct10l Overlock Foot (taiwan)

Blade Overlock Foot: Thanks to the knives on the front, it cuts the fabric from the front and zigzags from the back, giving the appearance of a smooth overlock stitch. It is suitable for simple use. It cannot be installed on Horizon series and embroidery models. It is produced in Taiwan. OVERLOCK FOOT INSTALLATION To install the 423S overlock foot, first adjust the settings on the machine to the position shown in the picture. (zigzag width can be 4-5)??Then the feet attached to it are removed and brought to the position shown in the picture.???The overlock foot to be installed?The upper fork part of the overlock foot is attached to the horizontal bar on the machine. (As shown by the red line), the side clamping legs of the foot are attached to the outside of the vertical foot-mounted rod as seen in the picture and the screw is tightened. ??After attaching the overlock foot, an image like the picture will appear. ?We installed the overlock foot, now it’s time to test it,? ATTENTION: If it is not installed as shown in the picture above, do not operate your machine to avoid damage. Check the process steps and renew it from the beginning. As seen in the picture, placing the fabric after cutting 2 cm will make it easier for the machine to pull the fabric.?Then, the fabric is placed as seen in the picture. Stitching is done. ?And the result ????NOTE: In order for the overlock foot to work, the hook on the needle must be removed or bent downwards.??